Skip to main content
User Image

Dr Jahangeer Ahmed

Associate Professor

Faculty

Sciences
Department of Chemistry
publication
Journal Article
2016
Published in:

Electrochimica Acta

Ultrafine Iridium Oxide Nanorods Synthesized by Molten Salt Method toward Electrocatalytic Oxygen and Hydrogen Evolution Reactions

Ultrafine iridium oxide nanorods (IrO2 NRs) were successfully synthesized using a molten salt method at 650 _C. The structural and morphological characterizations of these IrO2 NRs were carried out by powder X-ray diffraction, Raman spectroscopy and electron microscopic techniques. Compared to commercial IrO2 nanoparticles (IrO2 NPs) and previous reports, these IrO2 NRs show enhanced electrocatalytic activity to oxygen and hydrogen evolution reactions by passing either N2 or O2 gas in a 0.5 M KOH electrolyte before electrochemical measurements, including cyclic voltammetry, chronoamperometry and electrochemical impedance spectroscopy. Specifically, the current densities from the as-synthesized IrO2 NRs and commercial IrO2 NPs were measured in 0.5 M KOH electrolyte to be 70 and 58 (OER, deaerated, at 0.6 V versus Ag/AgCl), 71 and 61 (OER, O2, from _0.10 to 1.0 V versus Ag/AgCl at 50 mV/s), and 25 and 14 (HER, deaerated, at _1.4 V versus Ag/AgCl) mA/cm2, respectively. These results are comparable with, and in most cases, higher than reported data in the literature. Therefore, the current study reports not only a novel synthetic process for IrO2 but also a high efficient IrO2 nanostructure, and it is expected that these IrO2 NRs can serve as a benchmark in the development of active OER and HER (photo)electrocatalysts for various applications.

Publication Work Type
Original Research Paper
Volume Number
212
Pages
686
more of publication
publications

Brick shaped nanoparticles of nickel tungstate (NiWO4) were synthesized magnificently using the molten

salts process at 500 1C. Powder X-ray diffraction (PXRD) and electron microscopy…

2017
publications

Yttrium Ferrite nanoparticles were prepared by citrate precursor method at reasonably low temperature.

Morphological and elemental studies reveal the formation of monophasic orthorhombic…

2017
publications

Herein, delafossite CuCrO2 nanoparticles were synthesized through a polymeric citrate precursor method,

followed by heating at 900 C in air. The BET surface area of the CuCrO2…

2017